Ezeket a hozzávalókat lefordítjátok nekem?

Picture of Supplies

-1-8ft section of 1.5" Diameter PVC pipe

-3-2x4's

-4-6 Rollerblade wheels, preferably equal sizes. Skateboard wheels could work also.

-2-3 2' 6" Metal rods the diameter of the inside of your Rollerblade wheels, mine were 1/4".

-4-6 Metal end caps the size of your metal rod. They look like little hats. One is shown in the picture.

-2-36" Black Rubber Tie-Down Straps.

-2 bolts with nuts. About 2.5-3".

-4 pretty large washers.

-Some screws and some nails.

-A hacksaw

-If your rollerblades came with small spacers, keep them, but if not it''s really not important.

-A countersink bit isn't absolutely necessary, but allows the screw head to lay flush.

-Wood glue if you'd like.

-Preferably small table saw, but jig saw could work with a steady hand.

-A basic set of tools would come in handy. A wrench, hammer, and screwdriver were useful.

-And obviously, your rollers.

-The first nine supplies(except the rollerblade wheels) cost me only $35 at The Home Depot.

Köszi :)